Dear Members,

As announced before, we have completed the F430 rear bumper for "Challenge" look modification, we have installed it on a base F430 Coupè along our Carbon rear Moulding connector and both fit perfectly!


The Rear bumper is made of Fiberglass and carbon fibre prepreg autoclave molded and it is complete of all the internal fixing points as the original one.
The one you see in pictures below is for parking sensors EU models ( cod. 83111910) , but we can make it also for models without parking sensors. ( cod. 83111810).
For this first piece we have manufactured the Tailpipe Surrounds LH RH as well (cod. 68164700 -68164800), but these are optional at Customers choice since the original ones from the existent bumper can fit.
About painting the rear bumper is normally delivered not painted ( like in pictures), but we can eventually offer painting service on request in the following original pastel colours only : "Red Corsa", "Red Scuderia", " Yellow Modena".

The Carbon rear Moulding Connector is made of Carbon fibre prepreg autoclave molded, the carbon fabric used is the same of Ferrari factory, 3k 200gr plain. Finish is clearcote glossy , same Ferrari factory. We have manufactured it for both Coupè /Scuderia ( cod. 80869800) and Spider /16m models.(cod. 81624500)

For install we reccomend to refer to qualified Body Shops / Services with experience in Ferrari parts assembly.
If you need further informations you can reply to this thread or send a PM for quotations.

Best Regards
Nicolò C.

Here you can see some pictures:

Name:  Ferrari F430 rear bumper moulding connector Scuderia upgrade.jpg
Views: 63
Size:  67.1 KB Name:  Ferrari F430 rear bumper for moulding connector EU version.jpg
Views: 66
Size:  38.7 KBName:  ferrari f430 rear bumper collegatore.jpg
Views: 65
Size:  29.7 KBName:  Ferrari F430 rear bumper moulding connector.jpg
Views: 64
Size:  28.1 KBName:  Ferrari f430 carbon rear moulding collegatore scuderia spider 16m.jpg
Views: 65
Size:  41.9 KB