Activity Stream

Hi Thanks, I have discovered how to remove them, it is as I suspected, the caps over the Nuts holding the Wiper arms on have to come off, a friend...

Thanks Garvin I was thinking about a similar area under the side panels. Perhaps itÂ’s the fittings I have but having tried a few IÂ’m still not...

Hi Thanks, I do not want a mounting Bracket I am after a Satnav, Regards DM

Can't help with the 458 specifics but I use one of these in my car. https://www.amazon.co.uk/gp/product/B09FP4VLRP If you have a modern iPhone...

Hi all, thanks so much for all you input, I will definitely try the warm water one ( never thought of that) so well worth a try, I have had a look on...

Hi Ian, Relay will be mounted on the earth stud next to the +12V bus bar and the relay coil earthed here as well. Don’t worry unduly about spade...

Hi Garvin Have you a plan as to where you are going to site your auxiliary relay? I had a quick look at mine as I am considering doing something...

Hi Steve Are you still looking for one? I have a brand new Ferrari one if you get stuck :-)

John send me an email or pm me. James QUOTE=JohnJStewart;845402]The HE website describes these better than I could. These are second hand...

Ferrari item is made of junk materiel. I doubt any repair, if possible, would last... I would fit a Hills pin.

For the price; easiest to just buy the hill part.

They do pop up from time to time so good luck in your search. :thumbsup:

You can use heat to warm the ali without damaging anything else - it doesn't need to be smoking hot to make a difference. Think in terms of the ali...

Yup

"All in, it’s very hard to see a situation where AML doesn’t need another major cash injection within the next year." Or even within the next...

Glad that was helpful my old friend

Aluminium expands at about twice the rate of steel so heating up will help, and if the temperature is kept under 200 Celsius it wont effect any...

Perhaps some boiling water? Every little helps as they say.

HI, MWStewart, thanks I am afraid to put some heat on the Aly upright as I am sure it is heat treated for strength, also do not want to put any heat...

Thanks for that Mark. I do indeed use the zsame bit of hose from the jet wash power unit to to the lance, so maybe I need to get a second dedicated...

A bit of heat, and use two hammers to tap both sides of the taper (the upright) at exactly the same time.

I was too late, not fully booked.

Hi 355, Yes I have done lots of ball joints as you say a good whack with a hammer, but the 458 has an Aly upright and I am loath to do too much...

Enjoy. Be interested in your thoughts afterwards.

cool. :thumbsup: those that have driven it have a lot of positive things to say. ill be lucky to get a test drive when they make it to the...