Giles’ 360 Modena on-line scrapbook

[giles]

Running reports/road trips/photos


Sent from my iPhone using Tapatalk

[giles]

A thread to use as a virtual scrapbook of my ownership on my 360 Manual.....
Since Dec 2019 I’ve been to Scotland twice, including the NC 500, Wales a couple of times and a couple of FOC organised events. Somewhat of a departure for me as I’ve usually SORN’d my ‘special’ cars for the winter, so welcome to my rather liberating ‘daily’ 360 experience [emoji1303]


Sent from my iPhone using Tapatalk

[giles]

Photos from my recent trip to Scotland.....


Sent from my iPhone using Tapatalk

[giles]

A thread to use as a virtual scrapbook of my ownership on my 360 Manual.....
Since Dec 2018 I’ve been to Scotland twice, including the NC 500, Wales a couple of times and a couple of FOC organised events. Somewhat of a departure for me as I’ve usually SORN’d my ‘special’ cars for the winter, so welcome to my rather liberating ‘daily’ 360 experience [emoji1303]


Sent from my iPhone using Tapatalk

owned since December 2018*!
Giles

[Nosevi]

Some nice shots of your motor there

[giles]

Like most people when I pick up a new car I like to get it sorted to a good baseline condition and go from there. My 360 was being used regularly by the previous owner but still there were lots of things that needed addressing......
Initial jobs done/parts replaced since pick up:
Cambelt change at the main dealer before it went anywhere!
Radiator fans
Thermostat
Manifold to Cat rings x2
Exhaust from a 12k mile car as original had rattling active valves and the stainless was quite unsightly
3rd Brake light inoperable, fixed
Driveshaft heatshield re-secured
Mass airflow sensors x2
Clutch block
Angular speed sensor (crank position sensor) x2
Electric windows and HeVAC controls clear goo cleaned off
HeVAC panel bulbs
Adjust drivers door handle cable
Adjust passenger side drop glass
Oil pipe slight weep fixed
Rear discs & pads
Major service
Wheel bolts x20

Just completed the fabulous Welsh Weekend without any issues (big up to Mike and supporting team!), the 360 was really going well and thoroughly enjoyed the drive and social, great event, great people and fabulous roads!
Rather than wash it when I got back I’ve taken it in for the rear bumper and near side sill to be painted as these were the only untidy (i’m being a bit harsh and picky!) parts to the car, so soon that’ll be sorted too.
Next job once back from the body shop will be drivers seat leather side bolster to be replaced and finally a full detail.
I really love improving a car to a good standard, hopefully I’ll manage it with this one!
Happy days, Giles

[Mike01606]

Nice to meet you and Connie at the weekend Giles...If you want to keep this thread clean ask the mods to delete this (although I notice one of them has already 'contaminated' it )

We should have spent more time comparing notes....

I've done a lot of the items you list below....engine and gearbox mounts are also well worth changing if not done previously.
Was one of the fans seized or just looking a bit rusty?

On the exhaust front, I bought a very low miles OEM unit. It was like new inside and the guy said it had only been on a few weeks from new.
The tailpipes are the later design to the ones on my 2000 car and rattle like hell compared to the originals. It's on my to-do list to try and tension them to stop it. Otherwise the old ones are going back on.

[giles]

Hi Mike,
Both fans were seized hence needing new ones.
My recently fitted OEM exhaust looks great but is putting out lots of white powder deposits on the engine.
I know you can re pack the exhaust box, but not sure if that is on my priority list.
Once I’ve had the paintwork done I’m going to fit the OEM stone chip protection on the wheel arches, I will do the light detergent spray routine and hope for the best!
Not sure what you mean about cleaning up the thread..... looks ok to me
Cheers, Giles

[Mike01606]

As it’s your scrap book I wasn’t sure you wanted to keep it ‘clean’ ie without lots of others posting in it

If you know a decent TIG welder and can remove the exhaust it’s actually quite simple and very inexpensive to stop the white dust problem. I’ve done one and I’m about to do a second when I’ve a bit of spare time.
I’ll post it on my Argento 360 thread.

[giles]

A couple of photos from the March 2019 Scotland trip with the Hillman Imp Club, my first long drive with the car, and before you ask it came back on a truck with a failed crank position sensor, best MPG ever on the way home! [emoji1787]
Plus a couple of pictures - not my Bentley, house, or wife!! [emoji1787][emoji85][emoji1787]




Sent from my iPhone using Tapatalk